: Always start with a clean "reference edge" by trimming the factory edge of your plywood before making parallel cuts.
This system allows for repeatable parallel cuts without manually measuring and marking each piece.
Insert the tab into the middle groove and tighten the green knobs. Adjust the stop to your desired measurement. UwzCWe4JQ2VYrg4oyh4
: If you plan to use the Festool LR 32 Hole Drilling System for cabinet shelf pins, it is better to buy "holey" rails initially rather than buying standard ones and replacing them later. 2. Festool Parallel Guide System (FS-PA/FS-PA-VL)
: When using an MFT/3 Multi-Function Table, ensure the guide rail is long enough to clear the board at both the start and end of the cut to prevent kickback. 4. Alternatives & Enhancements Festool Parallel Guides : Always start with a clean "reference edge"
: Ideal for cross-cutting 4-foot or 5-foot (5x5) sheets with extra "run-in" and "run-out" space.
Selecting the correct length is critical to ensure the saw is fully supported during the entire cut. Adjust the stop to your desired measurement
: Recommended for ripping 8-foot sheets or edge-jointing lumber up to 9 feet. It provides a single, perfectly straight reference edge that is more reliable than connecting two shorter rails.