Reset the VL_13.Set_OnF.1.var to 0 only after physical inspection of the wiring harness.
The activation of the .Set_OnF (Set On Fail) flag suggests a hardware-level interrupt. Preliminary logs indicate that the module encountered a synchronization error with the master clock, forcing the sequence into a "Safe State" to prevent cascading thermal damage. 4. Recommended Actions VL_13.Set_OnF.1.var
The variable VL_13.Set_OnF.1.var was triggered during the . This flag is programmed to remain 0 (False) during nominal operations and switch to 1 (True) upon a secondary component failure detection. Initial State: 0 (Standby) Trigger Event: Voltage drop detected in Terminal Block 13. Final State: 1 (Active/Fail) 2. Performance Metrics Reset the VL_13